Tramp Oil Separators installation instructions

Home	FAQ	ABOUT US	INFO FOR DISTRIBUTORS
Tramp Oil Skimmers for Single Sumps	Portable Tramp Oil Pump/Skimmers	Filter Chips/Fines from Coolant Portable Sump-Side Pump/Filter Units In-Line Filters with Washable Elements In-Line Bag Filters to 1 micron In-Line Magnetic Separators	Filter Chips/Fines from Cutting Oil Portable Sump-Side Pump/Filter Units In-Line Bag Filters to 1 micron In-Line Magnetic Separators	Other Filtration & Separation Products Oil Skimmers for Hot Parts Wash Water Water Filters with Washable Elements Prefilters for EDM Water Clean Oily Wastewater for Safe Discharge Compressed Air Filters --Zero Maintenance Portable Coolant Mixing & Dispenser

SETUP OF TKO-6 ON TYPICAL MACHINE TOOL

Click Image to Magnify	Click Image to Magnify	Click Image to Magnify
1. Machine Tool: Hass VF-1	2. Mount CLO-1 magnetic frame on the back of the machine tool. Set TKO-6 into magnetic frame.	3. Front view of TKO-6 mounted on machine tool.
Click Image to Magnify	Click Image to Magnify	Click Image to Magnify
4. Open Accessory Box.	5. Attach oil drain hose.	6. Attach coolant discharge hose.
Click Image to Magnify	Click Image to Magnify	Click Image to Magnify
7. Float inlet device in sump. (Note: In photo, inlet device is floating under sump cover.) Attach extender hose from inlet device to prefilter.	8. Attach quick connect fitting to compressed air inlet valve.	9. Attach compressed airline and begin operation.
	Click Image to Magnify
	10. View of separator tank when operating. Note absence of air bubbles in coolant in separator tank.